Thirty years experience testing and manufacturing quality long life pins and bushings for high wear environments on vehicles and like applications.
  
 

INSTALLATION INSTRUCTIONS

KAISER QWIK KIT SPRING EYE/SHACKLE and BRACKET with ENCASED SEALS - page 2 of 2
 
TEST PIN for PUSH THROUGH FIT
4. Raise Spring up to hanger. For alignment, FIRST drive the short line-up pin into the spring eye (from the inside) until flush with hanger bracket. Then drive in the long line-up pin from the opposite side. Place the spring pin behind the long line-up pin so that the grease fitting hole can be seen. (See drawing). Drive both pins into the spring eye until spring pin is in position.
5. Pins are marked with an arrow pointing to the locking flat. Line up pin with hanger bolt pattern and tap into position for locking bolts. Complete Assembly.
GREASING

6. Greasing after assembly. Apply grease until it appears at each end of the bushing assembly between spring hanger. The grooving on the pin and bushing keeps the unit lubricated. Spring units take grease without jacking up the front end and will grease time after time without additional work.
CAUTION: Should grease appear at only one end - recheck the installation by removing the pin and checking the seals each end. Seals should appear smooth and even A. torn seal will allow the grease to flow unevenly and cause dry spots in the assembly. See your distributor for replacement.
 
 
 
 
V.W. Kaiser Engineering, Inc., 8642 Gleason St., Millington, Michigan 48746